To Replace A Fuse; To Do An Emergency Start Of The Engine; To Connect The Jumper Cables; To Charge The Battery - Husqvarna P 524 Manual De Usuario

To replace a fuse

A broken fuse is identified by a burned connector.
1. Remove the cover to get access to the broken fuse.
a) To replace the main fuse, remove the engine
cover. The main fuse is in a holder below the
battery. The right illustration shows P 524. The
left illustration shows P 524EFI.
b) To replace the fuse for the power outlet, remove
the side cover. The fuse for the power outlet is
below the control panel.
2. Pull the fuse from the holder.
3. Replace the blown fuse with a new fuse of the same
Technical data on page 44 .
type. Refer to
4. Attach the covers.
Note: If the main fuse breaks again a short period after
you replace it, there is a short circuit. Repair the short
circuit before you operate the product again. Let an
approved service agent help you.

To charge the battery

• Charge the battery if it is too weak to start the
engine.
• Use a standard battery charger.
CAUTION: Do not use a boost charger
or start booster. That will cause damage
to the electrical system of the product.
28
• Always disconnect the charger before starting the
engine.

To do an emergency start of the engine

If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.

To connect the jumper cables

WARNING: Risk of explosion because of
explosive gas that comes from the battery.
Do not connect the negative terminal of the
fully charged battery to or near the negative
terminal of the weak battery.
CAUTION: Do not use the battery of your
product to start other vehicles.
1. Remove the engine cover.
2. Remove the cover for the battery case.
3. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
4. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING: Do not short circuit the ends
of the red cable against the chassis.
5. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
6. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
7. Replace the covers.
C
D
242 - 003 -