Programming Information And Suggestions; Applications And Programming - WEG SSW-07 Manual Del Usuario

CALL NOW 800-985-6929
5.1 APPLICATIONS
AND
PROGRAMMING
38
CALL NOW 800-985-6929
http://www.automatedpt.com/

PROGRAMMING INFORMATION AND SUGGESTIONS

This chapter helps the user to set the types of starting controls
according to their applications.
ATTENTION!
Suggestions and important notes for each type of starting control.
ATTENTION!
To know the correct programming of the parameters, have your
load data on hand and use the WEG (Soft-Starter) Dimensioning
Software available at WEG's home page (http://www.weg.net).
If you are unable to use the software mentioned above, you can
follow some practical concepts described in this chapter.
Shown below are some characteristic curves with current and
starting torque behavior according to some kinds of control.
I/In T/Tn
Current
Torque
I/In
T/Tn
Current
Torque
Figure 5.1 - Characteristic curves of torque and current in a direct on-line start
http://www.automatedpt.com/
and by voltage ramp
Email: [email protected]
5
Chapter
Tn
Tn
Email: [email protected]