Mounting On Surface; Electrical Installation - WEG SSW-07 Manual Del Usuario

CALL NOW 800-985-6929
3.1.3.2 Mounting on
Surface
3.2 ELECTRICAL
INSTALLATION
CALL NOW 800-985-6929
http://www.automatedpt.com/
Figure 3.3 shows the installation of the Soft-Starter SSW-07 on the
surface of a mounting plate.
Figure 3.3 - Installation procedures of the Soft-Starter SSW-07 on a surface
DANGER!
The Soft-Starter SSW-07 cannot be used as an emergency stop
device.
DANGER!
Be sure that the AC input power is disconnected before making any
terminal connection.
ATTENTION!
The information below may be used as a guide to achieve a proper
installation. Follow also the applicable local standards for electrical
installations.
ATTENTION!
If a power isolating contactor or circuit breaker with minimum voltage
coil is not used at the first power on, then power up the electronics
first, adjust the trimpots that are necessary to put the SSW-07 into
operation and only after this energize the power section.
http://www.automatedpt.com/
Chapter 3 - INStaLLatION aND CONNeCtION
Email: [email protected]
15
Email: [email protected]