WEG SSW-07 Manual Del Usuario página 7

CALL NOW 800-985-6929
Chapter 1 - SaFetY INStrUCtIONS
Do not apply any high voltage test on the Soft-Starter SSW-07!
6
CALL NOW 800-985-6929
http://www.automatedpt.com/
NOTE!
In this Manual, qualified personnel are those trained to:
1. Install, ground, power-up, and operate the Soft-Starter SSW-07
according to this manual and the required safety procedures;
2. Use protection equipment according to established regulations;
3. Give First Aid.
DANGER!
Always disconnect the general power supply before touching any
electrical component associated to the Soft-Starter SSW-07.
High voltage may be present even after the power supply is
disconnected. Wait at least 3 minutes for the total discharge of the
capacitors.
Always connect the equipment's heatsink to the protection ground
(PE), at the proper connection point.
ATTENTION!
All electronic boards have components that are sensitive to
electrostatic discharges. Do not touch these components or
connectors directly.
If necessary, first touch the grounded metallic heatsink or use a
suitable grounded wrist strap.
If necessary, contact the manufacturer.
NOTE!
Soft-Starters SSW-07 may interfere with other electronic equipment.
Follow the measures in Chapter 3 to reduce these effects.
NOTE!
Read this manual completely before installing or operating the
Soft-Starter SSW-07.
http://www.automatedpt.com/
Email: [email protected]
Email: [email protected]