Maintenance And Cleaning - Abicor Binzel MF1-Rear Instructivo De Servicio

MF1-Rear
8 Decommissioning
NOTICE
• As the MF1-Rear is integrated into a welding system, the process for putting it out of operation depends on the robot
control system. Please make sure that the shutdown procedures for all components integrated in the welding system are
strictly observed.
1 Switch off the power to the robot control system.

9 Maintenance and cleaning

Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Close off the gas supply.
• Disconnect all electrical connections.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
WARNING
Risk of crushing
Hands can be drawn in and crushed.
• Do not reach into moving wheels.
WARNING
Risk of injury
Serious injuries may be caused by parts swirling around.
• When cleaning the wire guide with compressed air, wear suitable protective clothing, in particular safety goggles.
NOTICE
• Maintenance and cleaning work may be carried out only by qualified personnel (in Germany see TRBS 1203).
• Observe the provisions of EN 60974-4 Inspection and testing during the operation of arc welding equipment plus any
national laws and regulations.
• Always wear your personal protective clothing when performing maintenance and cleaning work.
BAL.0410.0 • 2018-08-15
8 Decommissioning
EN - 15