Control Elements - Abicor Binzel MF1-Rear Instructivo De Servicio

7 Operation
7 Operation
DANGER
Shortness of breath and poisoning caused by inhaling phosgene gas
When welding workpieces that have been degreased with chlorinated solvents, phosgene gas is formed.
• Do not inhale fumes and vapours.
• Ensure a sufficient supply of fresh air.
• Rinse workpieces with clean water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the welding area.
NOTICE
• The MF1-Rear may only be operated by qualified personnel (in Germany see TRBS 1203).
• As the MF1-Rear is integrated into a welding system, the operating instructions of the welding components, such as
welding torch and power source, must be observed during operation.
1 Switch on the robot control.

7.1 Control elements

1 CAT socket
Fig. 7 Overview of control elements
Symbol Description
Control lead port (2). Connect the connection plug to the control lead port (2) to establish signal
transmission.
Optional: only when using safety cut-out CAT2.
Connect the CAT socket (1) to the helix cable of the CAT emergency stop safety cut-out. The integrated
control lead will transmit the signal to peripheral devices.
Gas test trigger (black) (3). Press the trigger: gas flows. Check the gas volume.
Inching trigger (green) (4). Press the trigger once: wire is fed.
EN - 14
4
2 Control lead port
3
3 Gas test trigger 4
MF1-Rear
1
2
Inching trigger
BAL.0410.0 • 2018-08-15