Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel MFS-V2 Instructivo De Servicio

MFS-V2
Symbol Designation
Main switch Q1 (6) Fig. (11)
Switching state ON (LEDs are lit green, device fan is running)
Switching state OFF (E-Box and M-Drive currentless)
Key-operated switch S2 (4) Fig. (11)
Auto
Exclusively for systems with M-Drive. For all other versions, without function.
Hand
Switching state Automatic: Wire feed is functional without restriction with the cover (M-Drive) closed
Switching state Manual: The protective device is bridged. The Inching (wire feed) function is enabled with cover
(M-Drive) open.
The key can be removed in any switching state.
Inching trigger S3 (3) Fig. (11) or S7 (6) Fig. (12)
Press trigger, to feed wire
Init trigger S4 (2) Fig. (11) or S9 (16), Fig. (12)
After eliminating fault, press trigger. Internal control is reset to starting position.
Slave LED V2 (15) Fig. (11)
Status green = ready, status red = fault
Master LED V1 (1) Fig. (11)
Status green = ready, status red = fault
Gas test trigger S8 (1) Fig. (12)
Press trigger for gas flow.
Gas inlet (3)
Gas outlet integrated into the central socket (15).

8 Putting out of operation

1 Switch E-Box and M-Drive to currentless state on the main switch (6) .
 Fig. 11 E-Box operating elements on page EN-16

9 Maintenance and cleaning

Regular and lasting maintenance and cleaning are the prerequisite of a long life and a trouble-free function.
In doing so, observe the following:
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of maintenance, servicing, mounting,
dismounting and repair work:
• Switch off the power supply.
• Disconnect the compressed air supply.
• Pull the mains plug.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
DANGER
DANGER
8 Putting out of operation
EN - 17