Abicor Binzel MF1-Rear Instructivo De Servicio página 36

10 Troubleshooting
10 Troubleshooting
DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and damage to the device. The
product warranty will be rendered invalid if work is carried out on the product by unauthorized persons.
• Operating, maintenance, cleaning and repair work may be carried out only by qualified personnel
(in Germany see TRBS 1203).
Please observe the attached document 'Warranty'. Please consult your retailer or the manufacturer in case of any doubts
and/or problems.
NOTICE
• Please also consult the operating instructions for the welding components, such as the power source, welding torch
system, re-circulating cooling unit etc.
Fault Cause
Unit is not • Control system or component defective
ready for
operation
• Motor defective
• Motor control card fault. Fault cannot be
Wire is not fed eliminated by pressing the RESET trigger.
• When the wire feed trigger is pressed again, the
motor control card shows again a fault.
Tab. 10 Troubleshooting
11 Disassembly
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Close off the gas supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
NOTICE
• Disassembly may be carried out only by qualified personnel (in Germany see TRBS 1203).
• Please consult the operating instructions for the welding components, such as the power source, welding torch system,
re-circulating cooling unit etc.
• Observe the information provided in the following section:
 8 Decommissioning on page EN-15.
1 Disconnect the cable assembly from the wire feeder.
2 Remove the parts to be disconnected.
3 Disassemble the MF1-Rear.
 Disassemble the MF1-Rear in the reverse order. In doing so, please note: 6.2 Installing the MF1-Rear on page EN-10
EN - 18
Solution
• Ask a Binzel specialist to replace the defective control
system or component
 See eBOX
 See eBOX
 See eBOX
MF1-Rear
BAL.0410.0 • 2018-08-15