Yamaha 40 Manual De Instalación página 72

2. Install:
• Grommet 1
• Wiring harness 2
• Battery cable 3
• Warning indicator lead 4
NOTE:
Align the taped end a of the battery cable with
the end of the grommet.
3. Install:
• Cable stopper 1
• Rubber seal 2
• Shift cable 3
• Throttle cable 4
4. Adjust:
• Shift cable joint position
Adjustment steps:
• Set the shift lever 1 to the neutral posi-
tion.
• Align the center of the set pin 2 with the
mark a on the bracket.
• Adjust the position of the cable joint 3
until its hole aligns with the set pin.
• Install the clip 4 and tighten the locknut
5.
WARNING
The cable joint must be screwed in a
minimum of 8.0 mm (0.31 in).
63
E