Troubleshooting The Tractor - Craftsman 107.280340 Manual Del Operador

Tabla de contenido
Troubleshooting the Tractor
PROBLEM
LOOK FOR
REMEDY
i Brake pedal not
Fully depress brake pedal.
depressed.
i PTO (electric clutch)
Place in OFF position.
switch is in ON position.
Cruise control engaged.
Move knob to NEUTRAL/OFF
position.
i Out of fuel.
If engine is hot, allow it to cool, then refill the fuel tank.
i Engine flooded.
Disengage the choke.
Fuse is blown.
See authorized dealer.
i Battery terminals require
See Cleaning the Battery and Cables section.
Engine will not turnover
i cleaning.
or start,
i Battery discharged or
Recharge or replace battery.
dead.
i Wiring loose or broken.
Visually check wiring. If wires are frayed or broken, see authorized
dealer.
Solenoid or starter motor
See authorized dealer.
i faulty.
i Safety interlock switch
See authorized dealer.
i faulty.
Water in fuel.
See authorized dealer.
Gas is old or stale.
See authorized dealer.
Fuel mixture too rich.
Clean air filter.
Engine starts hard or
i Engine has other
See authorized dealer.
runs poorly,
i problem
i Low oil level.
Check/add oil as required.
Engine knocks.
i Using wrong grade oil.
See Oil Recommendations
Chart..
i Engine running too hot.
See authorized dealer.
Excessive
oil
i Using wrong grade oil.
See Oil Recommendations
Chart.
consumption.
Too much oil in
Drain excess oil.
crankcase.
Engine exhaust
is
i Dirty air filter.
See Servicing the Air Filter section.
black.
Choke closed.
Open choke.
Ground speed control
Depress pedals.
i pedals not depressed.
Transmission release
Move into DRIVE position.
lever in PUSH position.
Engine runs, but tractor
Mower drive belt is
See authorized dealer.
will not drive,
broken.
i Parking brake is engaged.
Disengage parking brake.
i Traction drive belt is
See authorized dealer.
broken or slipping.
22
Tabla de contenido
loading

Tabla de contenido