Outside Top Exhaust; Attach Mounting Plate To Wall - Haier HM1630 Manual Del Usuario

English
A. OUTSIDE TOP EXHAUST
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Adapting Microwave Blower
for Outside Top Exhaust
A4. Check Damper Operation
A5. Mount Microwave Oven
A6. Adjust Exhaust Adaptor
A7. Connect Ductwork
IMPORTANT NOTES:
Make sure the screws for the blower motor and blower plate are securely
tightened when they are reinstalled. This will help to prevent excessive vibration
Make sure the motor wiring has been properly routed and secured, and that
the wires are not pinched.
A1. ATTACH THE MOUNTING PLATE TO THE WALL
Attach the plate to the wall using toggle
bolts. At least one wood screw must be
used to attach the plate to a wall stud.
1. Remove the toggle wings from the bolts.
2. Insert the bolts into the mounting plate
through the holes designated to go into
drywall and reattach the toggle wings to
3⁄4" (19 mm) onto each bolt.
TO USE TOGGLE BOLTS:
3. Place the mounting plate against the
wall and insert the toggle wings into the
holes in the wall to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed flush against the wall
and that the plate is properly centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and thewall.
4. Tighten all bolts. Pull the plate away
from the wall to help tighten the bolts.
13
(VERTICAL DUCT)
Spacing for Toggles
More Than Wall
Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Bolt End