Tabla de contenido
Idiomas disponibles
Idiomas disponibles
C3.
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and a
hole large enough for the power cord to fit through.
•
Read the instructions on the TOP CABINET
TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the instructions on the
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
31-7000110 Rev. 1
Installation Instructions
C4.
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
1 Remove and save the two screws that hold the
blower plate in place. Slide blower plate from
under its retaining flange. Remove the cover plate
installed on the back. Remove and save screws
that hold blower unit to the oven
Retaining
Flange
2
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
3 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Oven
Roll the blower unit 90° so that fan blade
4
openings are facing out the back of the
oven.
Before Rolling
Back of
Oven
Blower Plate
Back of
Oven
After Rotation
Back of
Oven
After Rolling
Back of
Oven
21
Tabla de contenido
