Tabla de contenido
Idiomas disponibles
Idiomas disponibles
● Read the user manual before operating and follow all
safety information. Only use the meter as specified in
this user manual.
● Never use this meter on a circuit with voltages greater
than 600Vrms @ 50/60 Hz, Cat. III or 1000V, Cat. II.
● Never measure current while the test leads are con-
nected to the input jacks.
● Do not operate the meter if the body or test leads look
damaged.
● Do not perform resistance and continuity test on a live
circuit.
● Use extreme caution when measuring live systems with
voltages greater than 60VDC or 30VAC.
● Use extreme care when working around bus bars and
bare conductors.
● Do not use the meter in overrange/overload conditions
(OL).
● For accurate readings, change the battery when the
symbol appears.
1.1
International Electrical Symbols
Signifies that the instrument is protected by double or reinforced
insulation.
On the instrument, this symbol indicates a WARNING and that the
operator must refer to the user manual for instructions before
operating the instrument. In this manual, the symbol preceding
instructions indicates that if the instructions are not followed, bodily
injury, installation/sample and product damage may result.
Risk of electric shock. The voltage at the parts marked with this sym-
bol may be dangerous.
Refers to a type A current sensor. This symbol signifies that application
around and removal from HAZARDOUS LIVE conductors is permitted.
In conformity with WEEE 2002/96/EC
Clamp-on Meter Model 514
CHAPTER 1
INTRODUCTION
Warning
3
Capítulos
Tabla de contenido
