Scheppach 7906100710 Traduccion Del Manual De Instrucciones Originale página 20

Deflation of Air
If the tyre pressure is too high, use the deflation button
(2b) and slowly reduce the air pressure to the desired
value.
Compressed-air gun
• The blow-out gun is equipped with a quick coupling
connector (1b). Use the quick coupling connector to
connect the blow-out gun with the compressed air
supply.
• Activate the compressed air generator.
• Press the trigger (1a) to start the delivery of the air.
The farther the trigger is pressed, the stronger the
air jet will be.
• Release the trigger to stop the delivery of air.
• After work disconnect the tool from the compressed
air generator.
10. Maintenance and cleaning
m CAUTION
Disconnect the device from the compressed air supply
before cleaning it.
• To ensure proper functionality and a long lifetime,
diligent lubrication and maintenance is essential.
• For operating pneumatic tools clean air is required.
Corrosion residues, dust and dirt from the pneu-
matic pipes reduce the efficiency of the tool and will
cause technical problems.
• If necessary clean the units and the accessory with
a moist cloth.
• Do not use abrasive or aggressive chemicals as
benzene or thinner, which may dissolve plastic parts.
• Do not allow liquids to enter the tools and never im-
merse them into liquids. Water in the compressed air
inlet can damage the machine. Therefore it is rec-
ommended to drain the air lines and the compres-
sor in regular intervals! Also clean the air filters in
regular intervals.
Cleaning of the Tire pressure gauge
• Do not allow foreign substances and dirt to enter the
compressed air nozzle.
• Do not expose the manometer to vibrations or me-
chanical stress.
• Add a few drops of oil to the sealing of the trigger pin
in regular intervals. Apart from that the tyre inflator
is maintenance free.
20 | GB
Cleaning and maintenance of the compressed-air
gun
• Before cleaning or maintaining, first disconnect the
compressed-air gun from the air supply.
• Add a few drops of oil to the sealing of the trigger
pin in regular intervals. Apart from that the com-
pressed-air gun is maintenance free.
Air Pressure and Air Volume
• Operate the air tools with the pressure stated in
the technical data using a compressor with an air
suction capacity of at least 200 l/min. When using
higher pressure than the max. permitted pressure
for operating the air tool, its self life will be reduced
drastically. The ideal capacity is provided by com-
pressors with a suction capacity of 300–400 l/min.
• Only use air hoses with an inner diameter of at least
9 mm. When setting up the air pressure, always
keep in mind that the pressure will decrease approx.
0.6 bar when using a 10 m long hose with an inner
diameter of 9 mm.
Service information
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
11. Storage
1. Perform all general maintenance, which are in the
User's Guide in the Maintenance section.
2. Store all parts of the set in a dust and dirt-free lo-
cation.
12. Disposal and recycling
Notes for packaging
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.