Cleaning; Transport; Storage; Maintenance - Scheppach HC550TC Traducción Del Manual De Instrucciones Original

This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been
improperly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are
disconnected from electrical power when checking for
damage.
Electrical connection cables must comply with
the applicable VDE and DIN provisions. Only use
connection cables with designation H05VV-F.
The printing of the type designation on the connection
cable is mandatory.

13. Cleaning

m Attention!
Pull out the mains plug before carrying out any
cleaning and maintenance work! Risk of injury from
electric shock!
m Attention!
Wait until the equipment has cooled down completely!
Danger of burning!
m Attention!
Always depressurise the equipment before carrying
out any cleaning and maintenance work! Risk of injury!
We recommend that you clean the device directly after
every use.
• Keep the device as free of dust and dirt as possible.
Rub the device clean with a clean cloth or blow it off
with compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
28 | GB
• Clean the device at regular intervals using a damp
cloth and a little soft soap.
Do not use any cleaning products or solvents; they
could attack the plastic parts of the device. Make
sure that no water can penetrate the device interior.
• The hose and injection tools must be disconnected
from
compressor must not be cleaned with water,
solvents or similar.

14. Transport

To change the position of the device, lift the transport
handle and pull the device to the new location.
When transporting the device in a vehicle it must be
secured to the loading bed with straps.

15. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The
optimum storage temperature lies between 5 and 30
˚C. Store the power tool in its original packaging. Cover
the power tool to protect it from dust or moisture.
Store the operating manual with the power tool.

16. Maintenance

You require the following for maintenance:
• Open-ended spanner 17 mm (not included in the
scope of supply)
• Open-ended spanner 24 mm (not included in the
scope of supply)
m Attention!
Pull out the mains plug before carrying out any
cleaning and maintenance work! Risk of injury from
electric shock!
m Attention!
Wait until the equipment has cooled down completely!
Danger of burning!
m Attention!
Always depressurise the equipment before carrying
out any cleaning and maintenance work! Risk of injury!
16.1 Changing the V-belt (Fig. H to K)
To change the V-belt on the compressor, please be
sure to disconnect the device from the mains.
www.scheppach.com
the compressor before cleaning. The