Hilti SFD 2-A12 Manual Del Usuario página 12

Selecting the function
▶
Select the desired function.
Screwdriving
1.Set the torque and operating mode selector ring to the required torque.
2.Set the forward/reverse switch to the desired direction of rotation.
Drilling
1. Set the torque and operating mode selector ring to the
2.Set the forward/reverse switch to the "forward" position.
Switching on
▶
Press the control switch.
Speed can be controlled steplessly right up to maximum by varying how far the control switch
is pressed in.
Switching off
▶
Release the control switch.
Removing the accessory tool
1.Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2.Pull the accessory tool out of the chuck.
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶
Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone
as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels
of moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
• Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate
unnecessarily on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not
use cleaning agents containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the
contacts.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone
as these can attack the plastic parts.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that
they all function correctly.
• Do not use the product if signs of damage are found or if parts malfunction. Immediately have the
product repaired by Hilti Service.
8
symbol.
2235440
*2235440*