Draining The Oil - OFFCAR 7FRG-17R Manual De Instrucciones, Uso Y El Mantenimento

- Set temperature and use switch E to increase and switch D to decrease temperature.
- Press switch A for a few seconds until pilot light B above it comes on to override pre-heating function F and go
directly to the set temperature. The display always shows the current temperature value. To find out the set
temperature, just press key E. When the set temperature is reached, an acoustic signal will indicate 'appliance
ready'.
- In order to carry out 'RAPID' pre-heating, press A and keep F pressed for a few seconds until red light G above
the switch comes on. In this status the fryer works intermittently until the temperature of 100° C is reached.
The fryer automatically comes on again when the temperature falls below a set level, so that the oil is maintained in pre-
heating status. If you need to heat the oil to the set frying temperature, just keep switch F pressed for a few minutes until
luminous light G goes off. The appliance will then automatically reheat the oil if it falls below the required temperature.
- Press switch A (fig.9) STOP.
- Turn the knob (Fig.8) back position "0".
- Turn the knob (Fig. 7) back to the 'SWITCH-ON' position.
- Turn the knob (fig.7) to 'EVERYTHING SWITCHED OFF' position and turn off the gas stopcock behind the appliance.
- Switch off the circuit breaker.
- Place the lid on the frying compartments/frying compartments.
In order to drain the basin of the used oil, allow the oil to cool, open the fryer's door, fit the oil collection basin with the
relevant filter, if it has not already been inserted, and open the drain cock. The oil is discharged through the cock and the
basin empties. To keep the oil at its best, it is advisable to leave it in a cool place once it has been filtered.
RAPID DEVICE
OPERATING INSTRUCTIONS
TURNING OFF THE MAIN BURNER
TOTAL SHUTDOWN

DRAINING THE OIL

Pag. 17
A. Appliance START/STOP switch.
B. If LED is on, the source of heat is current.
C. Digital temperature display (accurate to +/- 1°
C).
D. Switch for setting falling temperature and
overriding acoustic
cooking temperature has been reached.
E. Switch for setting rising temperature.
F. Rapid activation/overriding switch.
If LED is on, Rapid is current.
G.
AVOID OVERHEATING OIL.
H.
alarm warning that