Idiomas disponibles
Idiomas disponibles
Operation (Fig.1)
GB
IE
NI
Switching ON/OFF and auto shut
down
Switching ON
Insert the mains plug into a suitable mains
socket. The LED indicator ( 7) will light in
RED when the temperature adjustment knob
was not on '0' stage.
Switching OFF
Pull the plug out of the mains socket to switch
off the device.
Auto shut down
There is a motion switch inside the device,
●
the heating element will be shut down
automatically 20 minutes after the last
movement of device, LED indicator(7) will
turn off at the same time.
Unplug and plug the device will re-heat
●
the heating element, LED indicator (7) will
turn on in RED.
Soldering (Fig.1, 6)
Caution! Smoke and vapor can
lead to headaches and fatigue if
inhaled.
The soldering gun has a rated power
output of 60 watts and is ideal for
electronic solders.
One hand operation makes it especially
easy for difficult-to-access and fine
soldering work.
Clean the soldering tip (1) on the moist
●
soldering sponge (not provided).
After cleaning, the soldering tip (1) must
●
be tinned (refer to tinning procedure).
Flux the intended soldering join if
●
necessary.
10
After GREEN LED indicator (7), point the
●
soldering tip(1) to the intended soldering
joint and heat it.
Squeeze the wire feeding trigger (5) to
●
feed solder wire(8) to soldering tip (1)
to melt it, keep Squeezing to feed solder
wire(8) until the entire soldering joint is
covered.
Withdraw soldering tip (1) immediately to
●
prevent overheating the molten solder.
Cool down the solder to harden and
●
avoid vibrations.
Note
►
The flux is either already contained in
the solder or applied separately. Ask the
advice of the retailer when buying solder
in order to choose the most suitable
solder for your intended purpose.
