Idiomas disponibles
Idiomas disponibles
GB
MT
Content
Installation ............................................................. 10
Preparation ....................................................................10
Fastening the power supply unit ........................................10
Assembling the charging station ........................................10
Positioning the charging station .........................................10
Laying the boundary wire ................................................11
Connecting the boundary wire to the charging station .........12
Fixing the charging station ...............................................13
Initial start-up ........................................................ 13
Changing the PIN ...........................................................13
Setting/deleting a schedule ..............................................13
Setting the operating times ...............................................13
Setting secondary areas ...................................................13
Spot mode / fi xed point mowing ......................................14
Setting the rain sensor .....................................................14
Working instructions .............................................. 14
Setting the cutting height ..................................................14
Manually interrupting/starting the operating cycle ..............14
Installation
Required tools (not included in delivery):
-
Phillips screwdriver
-
Wire stripper
-
Measuring tape
-
Hammer
-
Optional: Drill, drilling machine, two dowels, two screws
(>M5)
Do you need support? We offer an installation
service. Find out more on our website:
www.grizzlytools.de/service/maehroboter-installationsservice
Preparation
Regularly check the lawn for stones, branches, wires and
debris that could cause damage to the device and blades.
1. Sketch the garden.
2. Charge the battery (32).
3. Press the rulers out of the box.
10 cm
Fastening the power supply unit
Do not store the power supply unit lying directly
on the ground.
• The power supply unit should be placed at a height inaccessi-
ble to children (e.g. 160 cm).
• The screw head can have a diameter of 7 - 10 mm.
10
20 cm
30 cm >
1. Mark two drill holes with a pencil or similar.
2. Drill the holes with a drill bit suitable for the material.
3. Press two dowels into the drill holes.
4. Attach the power supply unit to the wall with two screws.
When drilling, be careful not to damage any
supply lines. Use suitable search devices to fi nd
these or consult an installation plan for guidance.
Contact with electrical cables can lead to electric shock
and fi re. Contact with a gas line can result in an ex-
plosion. Damage to a water pipe can lead to property
damage and electric shock.
Assembling the charging station
:
Illustration
1. Place the charging unit (22) with the two lugs fi rst into the
baseplate (21) of the charging station.
2. Press the charging unit (22) down so that it is fi rmly seated in
the baseplate.
3. Fix the charging unit (22) from below to the baseplate (21)
with the four enclosed screws (19).
Positioning the charging station
Course for laying line of boundary wire
160 cm (63 inches) minimum distance
200 cm (78.74 inches) minimum distance to wall
200 cm (78.74 inches) minimum distance to next
curve
100 cm (39.37 inches) minimum distance to next
curve
We recommend installing a roof for the charging station
(17) to protect it from weather damage.
1. Choose a level position for the charging station (17) near a
power outlet with at least 2 m distance from the boundary
wire to the front and 1 m to the rear.
Do not fi x the charging station until you have laid and
connected the boundary wire. Please refer to "Fixing
the charging station" for this.
