Idiomas disponibles
Idiomas disponibles
Connect the connector of the spring to the connector
of the upright rod.
Place the spring arm onto the upright rod.
CAUTION
Do not push the connection cable back into the rod
The connector can be damaged by squeezing
the cable.
If the connection cable, which runs through the joint,
is too long, it can be pulled back through the upright rod
into the roller stand.
Pull the cable back out of the upright rod and roll it up
in the roller stand.
Connect the same coloured strands of the lower upright
rod and the power supply unit.
Mount the power supply unit tub again using M3 screws
and serrated washers.
Align the thread in the spring arm with the opening in the
upright rod, then insert the M4 hexagon socket screw
and washer.
A
Attach the covers "A" again, one after the other. Ensure
that the cover "B" is positioned in the groove of both
covers "A".
DANGER
Danger to life through an electric shock.
Do not switch on the mains power supply before the
light head has been installed
ENG
B
35
