Idiomas disponibles
Idiomas disponibles
D
Insert wall bracket "A" (with end ring "C" and hood "B"
attached) into wall bracket "D" and at the same time pull
the connector through the rectangular recess.
E
F
Install the wall bracket in vertical alignment with the
locking screw and nut M8 "E" and tighten (20 Nm).
Tighten all 4 setscrews "F" (5 NM).
Connect the connector of the ceiling rod to the connector
of the power supply unit.
Slide the hood to the wall and screw tight with a ring
(0.5Nm).
C
B
A
4.3
Wall arm installation
WARNING
Risk of injury from spring arm springing up
The spring arm can open suddenly when the binding
agent is removed and cause injuries. Please remove
the binder carefully.
B
A
C
Pull off the covers "A" carefully.
Unscrew screws "C" and remove joint covers "B".
D
Carefully remove the rotary connector "D".
Install the wall arm.
ENG
A
33
