Idiomas disponibles
Idiomas disponibles
REMOVING THE ATTACHMENT FROM THE
POWER HEAD
Stop the engine or motor and remove the spark plug
wire, disconnect from the power supply, or remove the
battery pack.
Loosen the knob.
Push in the button and twist the shafts to remove and
separate ends.
ATTACHING THE J-HANDLE
See Figure 3.
The J-handle must be used to ensure the best control and
maximize operator safety when using the accessory. If the
power head to which the accessory will be mounted does
not have such a handle, install the handle provided.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1 along with hearing and breathing
protection. Failure to do so could result in objects being
thrown into your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or a quali-
fied service center for assistance.
ASSEMBLY
Place the bottom J-handle clamp on the drive shaft as
shown. Insert the tab on the top J-handle clamp into the
slot on the bottom J-handle clamp.
Insert the end of the J-handle between the clamps so
that holes align and handle will be located to the opera-
tor's left.
Push the bolt through the clamp and handle.
Install flat washer and wing nut to hold the assembly in
place.
Adjust the position of the handle.
Tighten the wing nut securely.
OPERATION
APPLICATIONS
You may use this product for the purpose listed below:
Sweeping dirt, grass, and other debris from driveways
and walkways
POSITIONING THE WHEELS
See Figure 4.
The position of the wheels can be adjusted to improve
comfort and stability.
Stop the engine or motor and remove the spark plug
wire, disconnect from the power supply, or remove the
battery pack.
Loosen, but do not remove, the bolts and nuts securing
the wheel mounting plate.
Move the wheel mounting plate toward the front or the
back of the attachment as desired.
Tighten bolts and nuts to secure the wheel mounting
plate.
USING THE BROOM ATTACHMENT
See Figure 5.
WARNING:
Engine housing on gas power heads may become hot
during attachment operation. Do not rest or place your
arm, hand, or any body part against the engine housing
during attachment operation. Only hold the attachment
as shown in Figure 5 with all body parts clear of engine
housing. Extended contact with the engine housing can
result in burns or other injuries.
6 — English
