ProBreeze PB-H02 Manual De Instrucciones página 6

it off until the room has cooled to a lower temperature and then it will switch on. The
radiator automatically rotates through an on-and-off cycle to maintain the current room
temperature according to the thermostat's setting. It is normal for it to heat up and cool
down periodically.
6. To turn off the heater, turn the power switch dial anti-clockwise to "O" OFF.
7. Unplug the heater from the electrical outlet when it is left unattended or is not in
use.
Note: It is normal for the radiator to make crackling noises when first turned on.
TIMER FUNCTION
― ―
Timer
Triangluar Point
Segments
(Figure 1)
The heater can be set to turn ON and OFF at specific times of the day. There are 96 segments
around the dial. Each of these segments represent a 15-minute time period.
Setting the Timer:
Note: When you first use the heater, all of the segments should point inwards.
Note: Do not turn the dial anti-clockwise.
1. Plug the heater in.
2. Set the power and temperature to the desired settings.
The triangular point will stay fixed, turn the dial clockwise around it so that the triangular
3.
point is pointing at the current time of day.
10 of 80 | English
4.
5.
6.
CLEANING AND STORAGE
― ―
Current Time 8:00AM
•
•
•
8 Segments Outwards
(Figure 2)
•
•
•
Push the segments outwards for the time period you want the heater to be turned on.
The heater will now cycle on and off according to these settings.
Once unplugged, the heater timer will stop and need to be reset.
WARNING: ALWAYS TURN THE HEATER OFF, UNPLUG THE
POWER CORD FROM THE ELECTRICAL OUTLET AND ALLOW
THE APPLIANCE TO COMPLETELY COOL DOWN BEFORE
HANDLING OR CLEANING IT.
WARNING: ALLOW THE HEATER TO COOL DOWN FOR 2
HOURS (120 MINUTES) BEFORE CLEANING.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE HEATER, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS HEATER DAMAGE WILL OCCUR.
Do not attempt to clean the heater in any other way than
that detailed by the manufacturer.
Clean the exterior surface of the heater by wiping it with
a soft, damp cloth. Dry the heater with a soft clean cloth.
Clean the air inlet and outlet grills regularly with a
vacuum cleaner, using the brush attachment to avoid
any dust build-up.
To store your product out of season, we recommend
using the original or similar size box.
Do not kink or wrap the power cord and plug around the
appliance, as this may cause the insulation to weaken or
split, particularly where it enters the appliance.
Store the heater in a safe, clean and dry place, away
from direct sunlight and out of reach of children when
not in use.
English | 11 of 80