HTW ESSENTIAL HIDE Manual De Usuario página 22

USER MANUAL
4. METHOD OF USE
• WATER INJECTION
When the water heater is used for the first time or used again after a prolonged interruption, you
must inject water. Open all valves in the pipeline and turn on the hot water faucet. When water
flows continuously, it responds that water heater has filled with water. Turn off the hot water tap,
keep Open the valve of the cold water pipe, make sure that cold water can be added automatica-
lly after hot water use. And make sure the device always be full of water.
• CONNECT THE POWER
Insert the plug into a reliable outlet, connect the power, the indicator power will be turned on,
according to the following method to adjust the power knob temperature control, the water
heater works immediately.
• TEMPERATURE REGULATION
Adjust the temperature using the temperature control knob. Turn in the direction clockwise to
increase the setting temperature, turn counterclockwise to reduce the setting temperature,
and the temperature setting range is approximately 75ºC at room temperature.
After setting the temperature, the water heater works automatically and the heating
indicator lights up.
When the water temperature reaches the setting temperature, the power will be cut off
automatically, and the heating indicator will light to enter the state heat preservation. When the
water temperature drops at any time, the water automatically reheats and the heating indicator
lights up. When set to "OFF", the water heater will not work.
20

LOW
OFF
Temperature control knob
ELECTRIC WATER HEATER
HIGH
ESSENTIAL HIDE