HTW ESSENTIAL HIDE Manual De Usuario página 19

Termo eléctrico
Idiomas disponibles
  • ES

Idiomas disponibles

ELECTRIC WATER HEATER
EQUIPMENT INSTALLATION
1.
After determining the installation position of the appliance, drill two holes with a spacing
of 62mm and a diameter of φ10mm in the horizontal direction of the wall according to
the size shown in the following figure, and the depth of the hole should not be less than
90mm.
2.
Align the two hanging holes on the back of the appliance with the two hooks on the han-
ging plate and pull down firmly so that the hanging holes hang on the hook.
Install the wall hole
WARNING:
The appliance must be hung securely to prevent personal injury and property
damage from falling.
Align the two hanging holes on the back of the appliance with the two hooks on the hanging
plate and pull down firmly so that the hanging holes hang on the hook.
Tube connection
The water inlet and outlet interface specification of this appliance is GI/2.
Connect the tubes according to the following figure.
1.
Connect the safety valve with attached gasket to the inlet port of the
appliance with the arrow pointing in the direction of flow.
2.
Insert the drain pipe into the bottom of the safety valve outlet, the other end
of the continuous downward for safe drainage (such as floor drain), the dra-
in pipe should be installation without obstacles, and the outlet of the safety
valve is connected with the atmosphere.
3.
When the water inlet pressure is greater than 0.55 MPa, an additional safety
valve should be added to the water inlet pipe.
ESSENTIAL HIDE
Water heater
2. INSTALLATION METHODS
wall
USER MANUAL
FACILITY
Hanging hole
Water heater
support
Plastic expansion
tube
Fixing screw
17
loading

Este manual también es adecuado para:

Htw-tv-15esshideHtw-tv-30esshide