SICE S 65 Manual De Instrucciones página 95

the lit icon shows the operator selected.
- Press the Enter button
Press the Exit button
-
- The selection can also be seen in the working screen status line.
By selecting a new operator, the machine resets the parameters that were active at the
last recall.
The stored parameters are:
- balancing mode; dynamic, ALU, motorcycle, etc;
- wheel dimensions: distance, diameter and width or those relating to the active ALU
programme;
- OPT: last OPT.
The machine's general settings remain the same for all working environments: grams/
ounces, sensitivity x5/x1, threshold, etc....
This procedure reduces the possible vibrations still present in running vehicles after an
accurate balancing. Based on our experiences, the programme can be recalled every time
it is convenient to minimise the running noise produced by the vibrations mentioned
above.
The machine also indicates whether or not it is necessary to carry out the procedure by
displaying the following icon
The calculations performed by this programme are based on the unbalance values
measured during the last spin performed which must therefore refer to the wheel being
serviced.
Proceed as follows to recall this programme:
- Select the OPT Flash icon
OPT STEP 1
1. take the valve to 12 o'clock;
2. press Enter
User manual S 65
to select the icon desired.
to save the setting and exit.
FLASH OPT
Optimisation Programme
in the status bar.
.
to confirm the operation;
UK
95