Connection Of Sample Changer Tw 7400; Using Software Titrisoft (Only Titroline ® 7000); General; Titrisoft 3.0 - Xylem SI Analytics TitroLine 6000 Manual De Instrucciones

167
Chapter 7 – Connection of Analytical Balances and Printers
Fig. 140
The settings of the RS232-1 (4800, No. 8, 1) remain unaffected.

7.4.2 Connection of sample changer TW 7400

The sample changer TW 7400 plus is connected to RS232-2 (RS2) of the titrator by cable TZ 3987. The settings
of the RS232-2 interface do not have to be changed. They can remain at 4800, No, 8,1.
®
7.5 Using software TitriSoft (only TitroLine 7000)

7.5.1 General

The titrator is connected to the PC via the RS232 or USB-1-B interface (only with a later release). Cables TZ
3097 and TZ 3091 can be used via RS232-1 for the connection.

7.5.2 TitriSoft 3.0

When using the new software 3.0 TitriSoft, the factory settings of the RS232-1 can be maintained. Reading and
writing the intelligent exchange units and ID electrodes is possible with TitriSoft 3.0. For more information, please
refer to the user instructions of TitriSoft 3.0.

7.5.3 TitriSoft 2.75

When using the TitriSoft 2.75 software, the settings of the RS232 interface must be changed to 4800, No. 7.1 for
compatibility reasons.
Note:
Data cannot be exchanged between the exchange units and the ID electrodes with TitriSoft 2.75!