Husqvarna 525LK Manual Del Usuario página 15

2. Move the choke control up into choke position.
WARNING:
will start to rotate immediately when you
start the engine with the choke.
To prepare a cold engine for start
1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Move the choke control up into choke position.
WARNING:
starts to rotate immediately when you
start the engine with the choke.
1027 - 004 - 13.03.2024
The cutting attachment
The cutting attachment
To prepare a warm engine for start
1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Pull the starter rope handle until the engine starts.
Push the throttle trigger slowly to increase the speed
gradually.
CAUTION:
rope to full extension. Do not let go of
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
To start the product
WARNING:
instructions in the safety chapter before you
start the product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION:
3. Hold the starter rope handle with your right hand.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawls
grip).
WARNING:
rope around your hand.
5. Pull the cord quickly and with power.
CAUTION:
rope all the way out and do not let go off
the starter rope handle when the starter
rope is fully extended. This can cause
damage to the product.
6. Pull the starter rope until the engine starts or for a
maximum of 5 times.
Do not pull the starter
Read the warning
Safety on page 5 ).
Do not use your feet!
Do not twist the starter
Do not pull the starter
15