When To Change The Thread Catchers; How To Replace The Thread Lifters; Cleaning The Roller On The Allteq Floorhead; Cleaning And Care - Miele SGDE0 Instrucciones Operativas

 Replace the cover and tighten the
screw.

When to change the thread catchers?

(only possible for models with a re-
versible floorhead included as standard)
The thread catchers on the suction inlet
of the reversible floorhead can be re-
placed. Check them from time to time
and replace them if the pile has worn
down.

How to replace the thread lifters

(Figs. 44 + 45)
 Use a suitable screwdriver to remove
the thread lifters from the slots.
 Install new thread lifters.
Cleaning the roller on the AllTeQ
floorhead (Fig. 46)
(depending on model)
Clean the roller on the floorhead if re-
quired.
 Release the bearing (with bayonet fit-
ting) using a coin.
 Press the bearing out, and remove.
 Remove the roller.
 Remove any threads and hair, replace
the roller and refit the bearing, locking
it back into position.
Replacement parts are available from
your Miele dealer or through Miele
Technical Service.

Cleaning and care


Always disconnect the vacuum
cleaner from the electrical supply be-
fore cleaning it. Turn off and unplug
it.
Vacuum cleaner and accessories
The vacuum cleaner and all plastic ac-
cessories can be cleaned with a propri-
etary cleaner suitable for plastic.

Do not use abrasive cleaning
agents, glass cleaning agents, all-
purpose cleaners or oil-based condi-
tioning agents!
Dust compartment
The dust compartment can, if neces-
sary, be cleaned using a dry duster,
brush or, if available, a second vacuum
cleaner to vacuum the dust out.
Monitor the filter bag change indicator
and inspect all filters regularly. Clean or
replace them when necessary accord-
ing to these Operating Instructions.

Do not let the vacuum cleaner
get wet. If moisture gets into the ap-
pliance, there is a risk of electric
shock.
en-US
25