CASO DESIGN HW 770 Advanced Manual Del Usuario página 67

Dispensador de agua instanáneo
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 111
3.2.2 Water disposal from the drip tray
1.
When the drip tray is full, grasp and stabilize the device
by one hand and use the other hand to lift up the drip
tray slightly to remove it.
2.
Lift it slightly to remove it.
3.
Remove the water from the drip tray and then hook it
back onto the appliance. Make sure that the drip tray is
xed to the device.
3.2.3 Replacing the water lter
1.
Remove the water tank lid (A) and remove the lter
holder (B) with the water lter (C).
2.
Follow the steps described in Section "Preparation
of the water lter".
PLEASE NOTE
Spare water lters are available separately.
Set of 6 = Caso Item No. 1841, Set of 3 = Caso Item
No. 1861
3.2.4 Error code Lo Lack of water
If the device stops and you hear a beep and see the error codes "Lo" and "Lack of water"
on the control panel display, then this means that there is either not enough or no water
in the tank. Fill the tank with water up to the "MAX. " mark.
3.2.5 Calibration
If you want to optimize the temperature or volume of water, then you can calibrate the
device. Fill the tank up to max marking.
Place vessel below the spout which can collect whole content of watertank.
Press and hold
-button for 3 seconds until „CAL" is displayed. When volume "000" is
Temp.
shown press
for con rmation. The device perfoms the calibration and beeps once
process is nished.
4 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and main-
taining the device. Please observe the notices to prevent damages due to cleaning the
device incorrectly and to ensure trouble-free operation.
A
CASO HW 770 Advanced
DE
EN
NL
SV
FR
IT
ES
RU
PT
TR
B
C
67
loading

Este manual también es adecuado para:

1889