Idiomas disponibles
Idiomas disponibles
DE
to set the device for use with a water lter. If you do so, then "Descale" will appear on the
EN
control panel display when 150 litres of water has been dispensed.
NL
You can use the
SV
this, con rm your selection by pressing the
FR
3.2 Use
IT
1.
Fill the watertank with water. Pay attention to the mark which shows the maximum
ES
water amount.
2.
Insert the water tank into the device and place its lid on top of it.
RU
3.
Place your cup or container on the drip tray. Make sure that the cup is located
under the water spout.
PT
4.
Plug the power socket into mains power.
TR
5.
Press the
6.
Press
Temp.
set the water volume.
7.
Press the
sed from the water spout. If you want to stop the water ow, then press the
The device will stop immediately.
3.2.1 „Favorite" -button
1.
Press
Temp.
set the water volume.
2.
Press the
presetting will be programmed on the button.
PLEASE NOTE
If only a small amount of water is dispensed, then the desired temperature may
di er. Preheat the vessel.
If device was not used for longer time there could be scale deposits despite water
lter. In this case let 100 ml with 100 °C run through the device.
The device has a reminder feature. The last settings which were saved will be stored
even if the plug is removed.
The ambient temperature changes everyday. This leads to di erent amounts of
water. It can vary up to +- 15%.
66
CASO HW 770 Advanced
-button to change between the "H1", "H2" and "FIL" modes. Following
Clean
-button to turn on the device.
-button to choose your desired temperature and press
-button to start the device. The pre-set water quantity will be dispen-
-button to choose your desired temperature and press
-button for a few seconds. The device will beep three times and the
- button for a few seconds.
-button to
Volume
.
-button to
Volume
