TEFAL Cake Factory INFINITY Manual Del Usuario página 12

en
Glass pots
Do not put the lids on the glass pots during cooking.
Pour into the Place the aluminium mould
glass pots into the device
Once cooking is complete, remove the mould and the glass pots from the Cake Factory—wear oven
gloves because these will still be hot—and allow to cool for 10 minutes before putting on the lids.
Leave the pots to rest for 2 hours, so they cool to room temperature, before putting them in the fridge.
Tart mould with baking tray
Ensure that the black Insert the baking tray
reflector is properly in into the device
place and attached to the
bottom of the appliance
Bread and brioche cooking
1. Baking tray for bread or brioche dough weighing up to 500 g.
Ensure that the black reflector Place the dough in the centre
is properly in place and of the baking tray
attached to the bottom of the
appliance
2. Non-stick aluminium mould for dough weighing more than 500 g.
- brioche dough weighing up to 1000 g
- bread dough weighing up to 800 g
Ensure that the black reflector Place the dough into the
is properly in place and centre of the mould
attached to the bottom of the
appliance
20
Place the glass pots into the Close the appliance
aluminium mould
Grease the tart mould Place the mould Close the appliance
then pour the cake into the baking tray,
batter into the mould ensuring that it is well
centred
Put the baking tray into the Close the appliance
appliance
Put the non-stick aluminium Close the appliance
mould into the appliance
Product overview
1 2 3
1
On/Off button
2 Back button
3 Minus button (–)
4
Plus button (+)
Preparation
1. Remove all packaging, stickers and other accessories from both the interior and exterior of
the appliance.
2. Prior to first use, thoroughly clean the different moulds using hot water and some washing-up
liquid, carefully rinse and dry.
Installation and connection
The appliance startup applies to all programs
1
3
8
7
6 4 5
5
OK/Start button
6 Control panel
7 Automatic programs
8
Manual program
1. Remove the adhesive protective
film from the interface
2. Turn on the appliance.
3. Next, wait a few seconds before
pressing the On/Off button. The
first program flashes, indicating
the "Program Selection" mode.
2
en
21