Idiomas disponibles
Idiomas disponibles
The total noise emission values specified and the total
vibration emission values specified can also be used for
an initial estimation of the load.
WARNING
The noise emission values and vibration
emission value can vary from the specified
values during the actual use of the power
tool, depending on the type and the manner
in which the electric tool is used, and in
particular the type of workpiece being pro-
cessed.
Try to keep the stress as low as possible. For exam-
ple: Limit working time. In doing so, all parts of the
operating cycle must be taken into account (such as
times in which the power tool is switched off or times
in which it is switched on, but is not running under a
load).
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
8
Assembly
CAUTION
Danger of injury!
Do not insert the battery until the battery-powered
tool is ready for use.
CAUTION
Danger of injury due to rotating blade. Only work on
the product when the blade is switched off and sta-
tionary!
ATTENTION
Always make sure the product is fully assembled
before commissioning!
ATTENTION
Ensure that the cable is not squeezed during assem-
bly.
8.1
Installation of the lower push bar
(3) (Fig. 3)
1. Fit the two lower push bars (3) in the holes (3b) pro-
vided.
2. Fasten each of these with a Phillips screw (3a).
8.2
Installation of the upper push bar
(1) (Fig. 1, 4)
1. Screw the upper push bar (1) to the lower push bars
(3) with one flat head screw (2a) and a locking nut
(2) on each side.
8.3
Fitting the cable holder (8) (Fig. 1,
5)
1. Clip the two cable holders (8) into the upper push
bar (1) and lower push bar (3) and secure the cable
(9).
8.4
Grass collection basket
8.4.1
Note:
The carry handle must be fitted on the upper side,
where the fill level indicator is also located.
1. Attach the carrying handle (5a) of the grass collec-
tion bag (5) to the holder provided on the top of the
grass collection bag (5).
2. Screw the carry handle (5a) firmly to the inside of
the grass collection basket (5) with two screws (5b).
www.scheppach.com
Fit the carry handle (5a) to the
grass collection basket (5) (Fig. 1,
6)
GB | 29
