Idiomas disponibles
Idiomas disponibles
1
For your safety
1.1
General safety information
–
Before using this product, carefully read the instructions for use.
–
Strictly follow the instructions for use. The user must fully understand and
strictly observe the instructions. Use the product only for the purposes
specified in the intended use section of this document.
–
Do not dispose of the instructions for use. Ensure that they are stored and
used appropriately by the user.
–
Only trained and competent users are permitted to use this product.
–
Do not use a faulty or incomplete product. Do not modify the product.
–
Notify Dräger in the event of any component fault or failure.
–
Comply with all local and national rules and regulations associated with this
product.
–
Only trained and qualified personnel are permitted to inspect, repair and
service the product as detailed in these instructions for use (see
"Maintenance", page 14). Further maintenance work that is not detailed in
these instructions for use must only be carried out by Dräger or personnel
qualified by Dräger. Dräger recommend a Dräger service contract for all
maintenance activities.
–
Use only genuine Dräger spare parts and accessories. Otherwise, the
proper functioning of the product may be impaired.
1.2
Product-specific safety information
–
This product is approved according to ATEX directive 2014/34/EU. It must
only be used under the conditions specified in the approval certificate.
–
Ensure that all site permits, procedures, and practices are followed when
installing, using, and maintaining the product.
–
The equipment is to be installed in places where there is a low risk of
mechanical damage.
1.3
Meaning of the warning notices
The following warning notices are used in this document to alert the user to
potential hazards. The meanings of the warning notices are defined as follows:
Instructions for use
|
Warning sign Signal word
WARNING
CAUTION
NOTICE
1.4
Trademarks
Trademark
Trademark owner
®
HART Communication Foundation
HART
The following webpage lists the countries in which Dräger's trademarks are
registered: www.draeger.com/trademarks.
The trademarks mentioned are only registered in certain countries and not
necessarily in the country in which this material is released.
2
Description
2.1
Product overview
The Dräger Flame 1350 is a multi-spectrum UV and IR flame detector. It uses
one UV sensor and one IR sensor, digital signal processing hardware and
firmware algorithms to interpret the radiant characteristics of flames. It can
operate independently; external control equipment is not required for normal
functions. The flame detector can be integrated into both Dräger and third-party
control systems.
The flame detector comprises the following main components:
For your safety
Classification of the warning notice
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
death or serious injury.
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
physical injury. It may also be used to
alert against unsafe practices.
Indicates a potentially hazardous situa-
tion. If not avoided, it could result in
damage to the product or environment.
|
en
5
