Idiomas disponibles
Idiomas disponibles
FinishControl 4000 18V
Charge/change the battery in good time. If the
machine switches off abruptly during work, material
splashes may occur.
9
STARTING OPERATION
1. Unscrew the container from the spray attachment.
2. Pour in the prepared coating material.
Do not overfill the
container.
3. Fit the filter to the feed tube (Fig. 8, 1)
StandardSpray spray attachment
Fit the appropriate filter to the feed tube
depending on the coating material used:
Low-viscosity coating materials Fine filter
Viscous coating materials
4. Screw the container firmly onto the spray attachment.
5. Connect spray attachment and FC 4000. (Fig. 2)
6. Insert battery.
Check
that
battery is securely
and firmly inserted. A
battery that becomes
detached
operation can cause
damage to property
or personal injury.
7. Switch on the main switch at the device. (all indicators
light up and the handle vibrates)
The device is now ready for operation.
10
SPRAYING TECHNIQUE
The FinishControl has a trigger with 2 pressure
points. In the first stage, the turbine sets the preset
operating pressure. If the trigger is pressed further,
the material is transported.
Operate trigger on the spray gun.
Test spray a piece of cardboard to ensure correct setting of the
spray pattern, spray jet width, material and air volume.
Hold the paint spray gun upright and maintain a constant
distance of about 3 - 10 cm to the object being sprayed. (Fig. 10)
Move the paint spray gun evenly either from side to side or up
and down. If the gun is moved evenly, it will produce an even
MAX
(red)
Coarse filter
(white)
the
during
STARTING OPERATION/ SPRAYING TECHNIQUE / BREAKS IN WORK/
TRANSPORTATION/ TAKING OUT OF OPERATION AND CLEANING
surface finish.
Always start spraying away from the object and avoid stop-ping
spraying whilst still on the object.
In case of excessive paint mist formation, adjust the air and
material flow respectively and alter the distance from the object.
11
BREAKS IN WORK
1. Switch device off.
2. During longer breaks, vent the container by briefly opening
and then closing it again.
3. Clean nozzle openings after an interruption in operation.
In using quick-drying or two-component coating
materials, do not fail to rinse unit through with
a suitable cleaning agent during the processing
period. Important: The application life of the material
can change as a result of heating. Therefore, please
consult the material manufacturer.
12
TRANSPORTATION
ATTENTION! Full containers have to be
closed tightly when transported in the
case. Do not lie the case on its side if it
contains full containers of paint.
13
TAKING OUT OF OPERATION AND
CLEANING
1. Turn the machine off.
2. Divide the spray gun. Press catch (Fig. 2, A) down slightly.
Twist the spray attachment and turbine in a counter
movement to disconnect them from each other.
ATTENTION! Never hold the spray gun
rear part under water or immerse it into
liquids. Clean the housing only with a
moistened cloth.
3. Unscrew the container.
Empty the remaining coating material into the original
container.
4. Unscrew feed tube with container seal. (Fig. 10)
The enclosed brush set can be used for particularly
effective cleaning of the spray attachment (examples
Fig. 11 and 13).
5. Clean feed tube and suction nozzle in spray attachment
with cleaning brush. (Fig. 11)
6. Clean the ventilating bore. (Fig. 8, 2)
EN
21
