Idiomas disponibles
Idiomas disponibles
4.5
Notes on programming
Below you find a description of how to program the AVS
settings are to be made as in the case of other automatic viscosity measurement devices and software
packages from SI Analytics
®
with the AVS
470 Viscosity Measuring Unit. Other users who are working for the first time with devices of
this kind should at first try out the various settings to gather some experience on their influence on the
measurements.
In the delivery state, all the settings are present in the form of so-called default or basic settings to which
they will also be restored in the case of a deletion of the memory contents.
In the operating mode used to create a method or to set the parameters of the ViscoPump or the system pa-
rameters, you can use the "ESC" key to return to the preceding screen.
4.6
Functional description
After power up, the following screen will appear
on the display:
SI Analytics
Viscosystem AVS
version: mmm dd yyyy
Viscosystem AVS
ViscoPump Check:
system check: OK
press Enter
Viscosystem AVS
ViscoPump Check:
system error
error removed?
®
. Users who are conversant with such devices will not encounter any problems
®
470
®
470
®
470
®
470 Viscosity Measuring Unit. In principle, the
Fig. 1 Power-up screen for 5-10 s
After the power-up screen has disappeared,
either of the two screens below may appear:
Fig. 2 System ok,
press "Enter" to proceed to Fig. 4
Fig. 3 System is not ok,
follow the error removal instructions; until the
elimination of the problem was confirmed.
If everything is ok, you you will be taken to Fig. 2,
As long as the error persists, you will be hold at
Fig. 3
If the ViscoPump III is operated without a
capacitive sensor for monitoring the safety bottle
(recommended for suction working mode), the
supplied dummy plug must be plugged into the
"Safety bottle" socket of the ViscoPump.
Otherwise, the error message "Safety bottle full"
appears as shown.
53
