Idiomas disponibles
Idiomas disponibles
ViscoPump parameter:
pressure
suction
ON
OFF
ramp:
30 %
pump power:
100 %
meas. delay:
1.0 f
time above N1:
1.0 f
ViscoPump parameter:
save parameters?
Yes
No
System parameter
language:
RS parameter:
documentation:
date/time:
back:
System parameter
language: deutsch
english
francais
espanol
italiano
System parameter
RS parameter:
2400 Baud
4800 Baud
9600 Baud
RS parameter:
Bit
Stopp
7
2
8
1
7
1
8
1
7
1
8
1
Parity
No
No
Odd
Odd
Even
Even
Fig. 23 Input mode for the ViscoPump
parameters from Fig. 4
Pressure/Suction action: Adjustable working mode
Ramp: This refers to the steepness of the
pressure increase in terms of scale sections
(1 - 50, default value = 15)
Pump power: % of the programmed normal value
Measurement delay: Between the individual
measurements: Value between 0.5 and 2
Above N1 Suction: Time of suction above the
upper light barrier. Value between 0.5 and 2
Pressing "Enter" will take you to Fig. 24.
Fig. 24 Input mode for the ViscoPump
parameter; prompt following Fig. 23
This prompt is issued for data integrity reasons to
avoid the automatic take-over of any erroneous
input or changes.
Yes means: accept and store data
No means: discard changes
Press "Enter" to return to Fig. 4.
Fig. 25 Input mode for the system parameters
from Fig. 4
Selection of the language: Proceed to Fig. 26
Selection of the RS parameters: Proceed to Fig. 27
Selection of the documentation: Proceed to Fig. 29
Set time and date: Proceed to Fig. 30
Possibility of returning to Fig. 4
Confirm, press the "Enter" key to jump to the function
Fig. 26 Input mode for the system parameters:
Language
Select from:
German, English, French, Spanish, and Italian
Press the "Enter" key to return to Fig. 25
Fig. 27 Input mode for the system parameters:
RS baud rate
Select the baud rate 2400, 4800, or 9600
Used to adapt to the RS printer
Press the "Enter" key to proceed to Fig. 28
Fig. 28 Input mode for the system parameters:
more RS parameters
At this point you can select the word length, the
stop bit, and the parity
Used to adapt to the RS printer Press the "Enter"
key to return to Fig. 25
57
