Idiomas disponibles
Idiomas disponibles
10.4 RECOMMENDED MAINTENANCE SCHEDULES
Maintenance Service Interval
Before each use or daily
Daily
Every 100 hours
Before storage
10.5 CHECK TIRE PRESSURE
Tire pressure should be checked periodically, and maintained at the levels shown below. Notice that these
recommendations may differ slightly from the "Max Inflation" stamped on the side-wall of the tires. Exceeding the
max inflation will lead to a tire explosion. The pressures shown provide proper traction and extend tire life.
Front caster wheels
Drive wheels
10.6 TORQUE VALUES
Particular attention must be given to tightening the drive wheel lug nuts and blade spindle bolts. Failure to correctly
torque these items may result in the loss of a wheel or blade, which can cause serious damage and/or personal
injury.
Torque values are given below:
Part
Wheel lug nuts
Blade spindle bolts
Wheel lug nuts only: It is recommended that these be checked after the first 2 hours of operation initially, then every
100 hours and following removal for repair or replacement.
English
Maintenance Procedure
•
Check the safety interlock system as mentioned in Safety Start Interlock
System section (Reference 2.4.12).
•
Check the roll over protection system (ROPS) as mentioned in Safety
Start Interlock System section (Reference 2.4.12).
•
Check the seat belt as mentioned in Inspect The Seat Belt section (Ref-
erence 2.4.10).
•
Inspect the blades.
•
Check for frayed and deteriorated insulations.
•
Check the contacts of all switches and brakes. If the P icon will show on
the LED display screen, the brakes have no error.
•
Clean under the cutting deck. Clean the area under the operator's seat
and near the battery. Remove all grass clippings, leaves, and debris from
the product before starting work.
•
Check the tire pressure.
•
Check the wheel-lug nuts.
•
Remove the battery and the start key from the product.
•
Perform all maintenance procedures listed above and thoroughly clean
the product.
•
Inspect the entire product for damaged, missing, or loose parts, replace or
tighten the corresponding ones before storage.
•
Paint chipped surfaces.
WARNING
Ft-lbs.
70-77
118
31
26-28 psi
18-20 psi
N.m
90-105
160
EN
