Idiomas disponibles
Idiomas disponibles
EN
3. Release or cut the four straps securing the front and rear wheel axles to the bottom frame.
4. Remove boxes containing the loose parts, assembly hardware and documentation.
5. Remove and set aside all accessible packaging and wrap from unit and parts. Do not discard the packing
material until you have carefully inspected and operated the product.
6. Inspect the product carefully to make sure no breakage or damage occurred during shipping.
When assembling loose parts to your mower, verify the part is assembled correctly, is properly tightened, and is
torqued correctly (where applicable) before proceeding to the next assembly step. Use of a mower that may have
been improperly assembled could result in serious personal injury.
Carefully read and understand the manual before driving the mower off of the frame. Failure to follow these
instructions can result in loss of control and result in death, serious personal injury, or property damage.
4
ASSEMBLY
This section describes how to assemble and adjust the
product.
CAREFULLY READ AND UNDERSTAND THE
SAFETY CHAPTER AND THE ASSEMBLY
INSTRUCTIONS BEFORE YOU ASSEMBLE THE
PRODUCT.
4.1
INSTALL THE ROLL BAR
1. Align the holes of the lower roll bar with the frame.
Use an 18 mm wrench to tighten the four bolts,
applying torque within the range of 30 - 37 ft-lbs (40
- 50 N·m).
WARNING
English
WARNING
WARNING
Note: In order to ensure proper alignment, avoid
fully torquing all bolts until the very end.
2. Align the holes of the top roll bar with the lower roll
bar. Install bolts, washers, and nuts in the bottom
12
