Idiomas disponibles
Idiomas disponibles
EN
Torch necks in preferred sizes and geometries complete the ROBO WH torch system. Equipment
parts and wear parts appropriate for the welding task at hand must be ordered separately. The
order data and ID numbers for the equipment parts and wear parts can be found in the current
product catalog. Contact details for consultation and placing orders can be found online at
www.binzel-abicor.com. The ROBO WH torch system may be operated using original
ABICOR BINZEL spare parts only.
WARNING
Hazards caused by improper use
If improperly used, the device can present risks to persons, animals and material property.
• Use the device according to its designated use only.
• Do not convert and modify the device to enhance its performance without authorization.
• Only qualified personnel are permitted to perform work on the device or system.
NOTICE
• The manufacturer is not responsible for the transport and handling of the torch once it
leaves the factory.
• Prior to initial commissioning, check the torch against the alignment gage and make
adjustments as needed.
• Consult the documentation for the welding components.
Technical data
Type
Type of
cooling
WH 241/
liquid
WH 241D
WH 455/
liquid
WH 455D
Tab. 1
EN product-specific torch data with reference to EN 60974-7
1According to EN 60974-7, the value for the alternating current (AC) with 70% of the tested direct current
value (DC) must be specified.
2Mixed gas according to DIN EN ISO 14175.
EN - 2
1
Load
DC
Electrodes ø Gas flow
2
CO2 M2
A
A
%
mm
320
280
100 0.8–1.2
450
400
100 0.8–1.6
Cooling data
rate
Supply
temperature
Max.
L/min
°C
10–20
50
10–20
50
BEI.0037 • 2020-12-14
ROBO WH
Flow
Flow
pressure
Min.
Min. Max.
L/min bar
bar
1.0
1.5
3.5
1.0
1.5
3.5
