Idiomas disponibles
Idiomas disponibles
Grasp endofHEPA c artridge f ilter and
pullitaway from pre-filter. Remove
cartridge f rom assembly.
The pre-filter ( O)canbecleaned w itha
brush andthen rinsed withwater. Allow
pre-filter todrythoroughly.
i
i
i
i
It is recommended
that the HEPA
cartridge filter be cleaned by tapping
either of the ends.
DO NOT tap soft
pleated sides of HEPA cartridge filter
as this could damage the filter.
Tap filter until no more dust particles fall
from the filter.
To re-assemble filter assembly, place
large knob of HEPA cartridge filter in
hole on bottom of pre-filter.
Snap top of HEPA cartridge filter into
place.
E_5[i]
!
Secondary
and
final
filters
Align grooves (H) on pre-filter frame with
grooves (I)in dirt cup.
Slide filter assembly down into cup until
a light snap is felt. Gently pull up on
assembly to ensure that it is seated
properly in the cup. Ensure that no part
of pre-filter screen extends above top
edge of dirt cup.
Replace lid and return cup to cleaner
(Fig. 3-4).
Cleaning
secondary
filter
Disconnect cleaner from electrical
outlet.
The secondary
filter (J), located behind
the grill in the bottom of cleaner cavity,
protects the motor from dirt particles.
If the filter becomes dirty, remove dirt
cup (Fig. 3-2). Remove screw and pull
grill out. Lift out filter.
Hand wash filter in cold water with mild
detergent,
then air dry.
Reposition dry filter, grill and screw.
Replace dirt cup.
Should you want to replace this filter, ask
for HOOVER part No. 38762008.
Let filter air dry and reposition it on the
side of cleaner.
Make sure the white
side of the filter faces outward. Close
door.
Should you want to replace this filter, ask
for HOOVER part No. 40110006.
Do not
operate
cleaner
without
any
of
the filters
in place,
Cleaning
final
filter
The final filter assists in the filtration
process to return clean air to the room.
To remove this filter when it becomes
dirty, open the door on the side of the
cleaner.
Lift out filter (K) and hand wash it in cold
water with mild detergent.
Reattaching
filter
door
Tile filter door is designed with a "break-
away" feature which allows it to snap
free if it is pushed open too far.
To reattach, align hinges (L) of cover
with slots on sides of filter area.
Press door back into place.
Continued
._
9
