Idiomas disponibles
Idiomas disponibles
P_4
B
Carpet
height
adjustment
The cleaning of carpet and rugs takes
place at the nozzle (A).
When it is necessary to raise and lower the
nozzle for various carpet pile heights, slide
the nozzle control knob (B) to the desired
setting.
C
i._ _
D
.z:
......
Handle
position
For ease in sliding knob, the handle
should be in the upright position (C).
The nozzle will not move into the
adjusted
position
until the cleaner
handle is lowered to the operating
position
(D).
IIIIIliil l......
Settings
For maximum cleaning performance,
the following carpet height settings are
recommended.
• Lowest setting: for bare floors and all
types of carpet
Note: If the cleaner is difficult to push,
slide knob to the next higher setting.
• Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good cleaning
performance.
Cleaning
lightweight
flexible
rugs
Stand on one end of rug and move
cleaner toward other end or edge.
Before reaching edge, push down on
handle. This will lift up the nozzle (front
of cleaner) and will prevent rug from
clinging to cleaner. Continue to lift up
nozzle so that when you have reached
the edge, it is completely
off the rug.
Move cleaner back to start again, lower
nozzle, and use only forward strokes.
Edge
cleaning
Special edge groomers are provided on
both sides of the nozzle to remove dirt in
carpet near baseboards
and furniture.
Guide either side of nozzle parallel to
edge of carpet or furniture.
Stair
cleaning
Use the hose and powered
hand tool*
or furniture
nozzle
for stair cleaning.
Clean
from bottom
to top.
When
using
cleaning
tools,
the
agitator
will
continue
to rotate.
CAUTION:
To avoid
personal
injury
or
unnecessary
wear
to carpet,
and to
prevent
the cleaner
from
falling,
always
place
it at bottom
of stairs.
*some
models
only
