Proxxon EP/A Manual página 20

1 x Foam backing pad with hook and loop
quick fastener (Ø 50 mm)
1 x Polishing sponge (medium hard)
1 x Lambskin polishing disc
1 x Polishing felt (medium hard)
12 x Sanding discs (K 2000)
1 x Microfi bre cloth
1 x Wrench
EP/A (29837):
1 pc. Battery-powered Random orbital polis-
her EP/A
1 pc. Operating instructions and safety gui-
delines
1 x Foam backing pad with hook and loop
quick fastener (Ø 50 mm)
1 x Polishing sponge (medium hard)
1 x Lambskin polishing disc
1 x Polishing felt (medium hard)
12 x Sanding discs (K 2000)
1 x Microfi bre cloth
1 x Wrench
4 Technical data
Device:
Rotational speed:
Voltage:
Disc diameter:
Length:
Weight:
Eccentricity:
Noise generation:
General measuring
uncertainty:
Grip vibration:
Charger:
Mains voltage:
50/60Hz
Output voltage:
Charging current:
Battery:
Rechargeable lithium-ion battery
Nominal/charging voltage: 10.8V/12.6V
Energy/Capacity:
- 18 -
1100-2600min
10.8 V
max. 50 mm
approx. 320 mm
approx. 850 g
5.5 mm
≤ 78 dB (A)
K=3dB
2
≤ 2.5 m/s
100-240 V~,
12.6 V
1 A
28.19Wh/2.61Ah
3 INR 19/66
5 Noise/vibration information
The information on vibration and noise emissi-
on has been determined in compliance with the
prescribed standardised and normative measu-
ring methods and can be used to compare elec-
trical devices and tools with each other.
These values also allow a preliminary evalua-
tion of the loads caused by vibration and noise
emissions.
Warning!
Depending on the operating conditions, the
emissions that actually occur may deviate from
the values given above!
This applies in particular depending on the
workpiece to be machined and the insert tool
(especially its wear condition). Unsuitable
workpieces or materials, poorly maintained
tools, too high a feed rate or unsuitable insert
tools can signifi cantly increase the vibration
load and noise generation.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched off,
or is running but is not actually in use. This can
clearly reduce the vibration and noise load ac-
ross the entire work period.
Warning!
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable
bits and cutters!
• Take breaks if necessary when working with
the device!