Idiomas disponibles
Idiomas disponibles
7. Turn the oil filter counterclockwise to remove it.
8. Lightly lubricate the rubber seal on the new oil filter
with new oil.
9. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
10. Fill with new oil as given in
82 .
11. Start the engine and let it idle for 3 minutes.
12. Stop the engine and make sure that the oil filter does
not leak.
13. Fill with oil to compensate for the oil held in the new
oil filter.
Note:
For safe disposal of used engine oil, see
Disposal on page 80 .
To do a check of the transmission oil
level
1. Use the oil dipstick to read the oil level in the
transmission.
62
Technical data on page
2. The oil level must be between the marks on the
dipstick.
3. If the oil level is too low, fill with the type of oil given
Technical data on page 82 .
in
To do a check of the oil level in the
hydraulic system
1. Tilt the seat forward.
2. Clean the area around the oil cap with a dry cloth.
3. Remove the oil cap and examine the hydraulic oil
level. Correct level is 40–60 mm from the top of the
strainer.
4. If the oil level is too low, fill with the type of oil given
Technical data on page 82 .
in
To adjust the hydraulic pump belt
1. Fold the operator seat forward.
2. Remove the protection plate below the seat.
1929 - 003 - 05.12.2023
