Idiomas disponibles
Idiomas disponibles
•
Push the power switch to position (C) to make the
high beam light and the work light come on.
The work light stays on for 3 minutes after the ignition
key is set to STOP. When the headlights are on, the
display shows the headlight symbol. Refer to
page 7 .
Warning lights
Note:
The warning lights automatically come on when
the product is in remote control mode.
The product has front and rear warning lights.
•
Push the power switch to position (A) to make the
warning lights go off in manual mode.
•
Push the power switch to position (B) to make the
warning lights come on in manual mode.
Forward and rearward pedals
The speed is gradually adjusted with 2 pedals. The left
pedal (A) is used to move forward, and the right pedal
(B) is used to move rearward. The product brakes when
the pedals are released.
6
Display on
A
B
A
B
Switch for electric lift of the cutting deck
The switch controls the electric lift. Use the electric lift to
lift and lower the cutting deck into correct position.
The switch has no set position. Pull the switch for the
electric lift rearward to lift the cutting deck. Push the
switch for the electric lift forward to lower the cutting
deck. The cutting deck can always be lifted and lowered
when the ignition key is in ON position.
The cutting deck must always be in float position when
you cut grass. The float position let the cutting deck to
follow the different levels of the ground.
Cutting deck
The cutting decks for this product are the Combi cutting
decks and the (R137) cutting deck. The cutting decks
are also available as X-models, that let you adjust the
cutting height from the control panel. Refer to
data on page 82 .
The cutting decks operate with a mulch plug or with
rear discharge. When the cutting decks are operated
with the mulch plug, the grass is cut into smaller pieces
that become a fertilizer for the lawn. When the mulch
plug is removed, the cutting decks release the grass
rearward. The Combi cutting decks are specially made
for mulch plug use while the (R137) cutting deck are
specially made for rear discharge.
Technical
1929 - 003 - 05.12.2023
