Daily Startup; Shutdown - Porter Cable PXCM601 Manual De Instrucciones

DAILY START-UP (Fig. 6)
1. Check the oil level in the pump (see "Checking the Oil" in the maintenance
section on page 14).
2. Make sure the main power disconnect switch is shut OFF.
3. Close the tank drain valve (E).
4. Turn ON the main power disconnect switch. Turn the pressure switch to the
AUTO position (D). The pump will start filling the tank with air. When the air
pressure in the tank reaches the level preset at the factory, the pressure
switch will turn off the electric motor. As air is used and the pressure level
in the tank drops, the pressure switch will start the motor and the pump will
begin refilling the tank.
prevent burns or other injuries, DO NOT touch the pump or outlet
tube while the pump is running. Allow it to cool before handling or
servicing. Keep children away from the compressor at all times.
NOTE: If the unit does not operate properly, SHUT DOWN
IMMEDIATELY, and contact a qualified service center.
SHUTDOWN (Fig. 6)
1. Turn the pressure switch to the OFF position (C).
2. Shut OFF the main power disconnect switch.
3. Reduce pressure in the tank through the drain valve. You can pull the tank
safety valve ring (G) and keep it open to relieve pressure in the tank.
may cause eye injury. Wear safety goggles when opening
drain valve.
when using an air compressor. Failure to do so may result in
hearing loss.
4. Open the drain valve (F) to allow moisture to drain from the tank.
OPERATING INSTRUCTIONS
High temperatures are generated by the pump. To
Escaping air and moisture can propel debris that
Risk to hearing. Always wear hearing protection
13 - ENG