Idiomas disponibles
Idiomas disponibles
20.1.5
Disassamble/assemble the flange
20.1.6
Dressing grinding wheel
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
•
Place the wheel puller (4) in the flange and screw it in with
the wrench (5) (right-hand thread) until the grinding
wheel comes loose.
Secure the spindle (6) behind the grinding wheel with a
•
wrench.
Remove the grinding wheel
•
Assembly the flange to the new grinding wheel
•
•
Place the new grinding wheel onto the spindle
•
Put on the flange screw
•
Tighten the flange screw again
•
Close the grinding wheel guard and grinding table guard
(Pay attention to the position switch!)
Loosen flange disc (1) with grinding wheel wrench (2)
•
(right-hand thread)
•
Remove flange disc (1), spacer (3) and disc holder (4).
Assembly to the new grinding wheel in reverse order
•
Dressing with grinding wheel dressing unit
Open grinding table guard and grinding wheel guard
•
Place the dressing mandrel (3) close to the centre of
•
the grinding wheel (the dressing mandrel must not
yet touch the grinding wheel!), to do this loosen the
Allen screw (1) and move the rod (2)
Fix the Allen screw in the desired position
•
•
Close the grinding wheel guard and grinding table
guard (Pay attention to the position switch!)
•
Switch on the grinding wheel
Move the lever (1) back and forward and turn the set
•
screw (2) to feed the dressing mandrel carefully
against the grinding wheel to remove the material.
•
Stop feeding with the set screw and carefully move
the lever back and forward until no more material is
removed
Check the grinding wheel for flatness and repeat the
•
process until the desired result has been achieved
After finishing return the dressing mandrel to the
•
uppermost position
MAINTENANCE
57
FSM25AUTO
