Idiomas disponibles
Idiomas disponibles
EN
DE
ES
FR
IT
Charging of the signal controller
Connect the signal controller to the power
supply. The magnetic plug prevents incorrect
connection of the application module to the
power supply.
The signal control is fully charged when all the
LEDs of battery status light up green.
A full charge it will takes about 5-7 hours.
Simultaneously charge two signal
controllers with the Y-adapter
Connect the Y-adapter to the power supply. The
magnetic plug prevents incorrect connection of
the Y-adapter to the power supply.
You can now connect one signal controller to
each plug. Here again, magnetic plugs pre-
vent incorrect connection of the application
modules to the Y-adapter.
Error codes of the signal controller
Error messages of the signal controller
P1-P3 light up red (all)
The first LED on the battery display lights
up orange
P1 and P3 flash red and P2 flashes orange
P1-P3 light up blue
NL
PL
PT
DK
FI
No connection to the applicator
The battery charge level is too low for starting
the treatment
The battery temperature is too high
Battery error
For error messages that are not described here, please contact service.
15
LT
NO
SE
HU
CZ
Cause
SK
CN
Troubleshooting
Please contact service
Please connect the controller
to the power supply
Please contact service
Please contact service
