Idiomas disponibles
Idiomas disponibles
OPERATION
C/ock and Timer
Your new control has a series of tones that
will sound at different times, These tones
may sound while you set the control for an
oven function,
or at the end of the oven
function.
It will also alert you that there
may be a problem
with the functions
Below are the types of tones and a brief
description
of each,
TONES WHILE SETTING THE
CONTROL
- When you press a touch pad
you will hear a beep. This beep will let you
know you have placed enough pressure
on the pad to activate
it,
END OF TIMED CYCLE TONE - At the
end of a timed cooking
function, you will
hear 3 short beeps followed
by 1 beep
every 6 seconds.
This 6-second
beep will
continue to sound until the CLEAR/OFF
pad is pressed,
or you may select the
special feature to cancel this 6-second
beep from sounding
at the end of future
cycles.
TO CANCEL
THE 6-SECOND
BEEP:
1. Press and hold the BAKE and BROIL
pads, at the same time, for 3 seconds,
until the display shows "SF."
2. Press the HR/MIN KITCHEN TIMER
ON/OFF pad. The display wilt show
"CON BEEP"
(continuous
beep).
3. Press the HR/MIN KITCHEN TIMER
ON/OFF pad again. The display will
show "BEEP"
(beep canceled),
4, Press the START pad,
If you would like to return the 6-second
beep, repeat steps above until the display
shows your choice and press the
START pad.
ATTENTION
TONE - This tone will sound
if you make an error or an oversight
is
made while setting an oven function.
Examples
would be:
a. Setting a clean cycle and the oven
door is not properly
closed
b. Setting function and not pressing
the
START pad.
c. Pressing an additional
function pad
without first setting a temperature
or
timer
d=
"ERR"
will flash if you set an invalid
temperature.
Press the CLEAR/OFF
pad to clear the control and reset your
oven function,
Any of these can be quickly
identified
by
watching
the
displayr
PREHEAT
TONE - When you start a bake
operation,
the oven automatically
starts to
heat. When the temperature
inside the
oven reaches the temperature
you have
set, a tone will sound to let you know the
oven is ready for baking.
If you set an oven function
and the control
beeps while the display
is flashing
"F"
and a number "F-4"
or letter "FI," there
may be a problem
with the control. Simply
press the CLEAR/OFF
pad and wait
about an hour. Try setting the function
again. If the code repeats, write down
the code and call for service. Tell the
technician
what code was flashing.
18
