Sicam SBM 60 Manual Original página 39

4.3 Fitting the wheel guard
i
The back of the SBM V85 A contains 4 blind rivet
nuts countersunk in the housing wall.
1. Fasten the supporting arm to the SBM V85 A.
To do so, screw the 4 supplied Allen screws and 4
washers into the blind rivet nuts and tighten (width
A/F 6).
Fig. 6: Fastening the supporting arm to the SBM V85 A.
1 Supporting arm
2 Allen screw
3 Washer
4 Blind rivet nut
4.4 Fitting monitor
i
The back of the SBM V85 A contains 4 blind rivet
nuts countersunk in the housing wall.
1. Fasten the supporting arm to the SBM V85 A.
To do so, screw the 4 supplied Allen screws and 4
washers into the blind rivet nuts and tighten (width
A/F 6).
1
3
2
Fig. 7: Fastening the supporting arm to the SBM V85 A. 1 Supporting arm
2 Allen screw
3 Washer
SICAM srl soc. Unip
4
2
3
1
Commissioning | SBM V85 A | 39
2. Attach the rubber ring to the support arm, as shown
in the illustration. Insert the rings between the
mounting plate and the monitor to prevent that the
parts shift.
3. Fasten the monitor to the support arm. For this
purpose, screw on the bracket with 4 screws and 4
washers.
Fig. 8: Fitting monitor
1 Allen screw
2 Washer
en
|
1 695 600 571 2016-08-23